        Ŀ
                        MACRONIX INTERNATIONAL CO., Ltd.               
           PCI BUS FAST ETHERNET ADAPTERS SOFTWARE DRIVER SUPPORT      
                                                                       
             Copyright 1995-1999 Macronix International Co., Ltd.      
                             All rights reserved.                      
        

How to Config Your PCI adapter.
-------------------------------
 1. Firstly , you must find the PCI configuration item in BIOS setup.

 2. There are some key points you must take care of.

   a).  You should know what slot your adapter plug in. You can find the
        slot number in your mother board or its operating menu.

   b).  Enable this device.

   c).  Enable "master" this item.
        The MXIC' PCI Bus Fast Ethernet adapter MUST be installed in a
        bus master PCI slot.  Refer to your system documentation to
        determine which slots support bus mastering.

   d).  You can choose what interrupt line you used in some BIOS setup.
        For MXIC' adapter, you must choice "INT A" in this item.

   e).  Choose what interrupt number you want. You can assign it in what
        interrupt you choose or in the slot number you choose.

 3. When you finish your configuration. You can run the diagnostic program
        in the driver diskette. If any problem, please contact your dealer.

NOTICE !!

        Conflict with Microsoft EMM386
        -------------------------------

        Problem:
        If there is any version of EMM386 prior to version 4.49 on the
                DOS system,  when users run MX98713 drivers for a 32-bit I/O
                read/write which will cause the system to be hang and/or reset.

        Fix:
        Use version 4.49 or higher releases of the EMM386 memory manager(
        available with MS-DOS version 6.22).
        End-users with earlier version of the EMM386 memory manager should
        contact their OEM or Microsoft for information on obtaining an
        updated EMM386 device driver.
