   Driver Installation - for LAN Server 4.0

   (1) Introduction:
   
   This document describes the procedure to install NDIS driver on DOS
   LAN Requester and OS/2 LAN server 4.0 for MXIC PCI Fast Ethernet 
   Adapters.

   Location of Driver:  \NDIS20DOS\MXNICF.DOS        (for DOS LAN Services)
			\NDIS20OS2\MXNICF.OS2        (for OS/2 LAN Server)


   (2) Installing Driver Procedure on DOS LAN Requester:
   
      Before you start with the installation process, make sure that
      DOS LAN Services is properly installed. Similarly, your adapter
      should also be properly installed in your client PC.

      1. Copy MXNICF.DOS from your Driver diskette (A:\NDIS2DOS) to DOS
	 LAN Services subdirectory C:\NET.

      2. Under DOS LAN Requester subdirectory C:\NET, run INSTALL.

      3. The screen display some description. If it's correct, move
	 highlight to "The listed options are correct" item ,then press
	 ENTER.

      4. Move highlight to "Network Card", then press ENTER.

      5. Select "Change driver for network card." item, then press ENTER.

      6. Select "Network card not shown in list below..", then press ENTER.

      7. Insert the MXIC adapter driver diskette in floppy A,and specify 
	 the pathname A:\NDIS2DOS,then press ENTER.

      8. MXIC adapter driver is now installed on your computer, reboot your
	 computer.


   (3) Installing Driver Procedure on OS/2 LAN Server 4.0:
   
      Before you start with the installation process, make sure that
      OS/2 LAN Server is properly installed. Similarly, your adapter
      should also be properly installed in your server.

      1. In OS/2 window, Click the "MPTS" icon.

      2. The screen will display the IBM Log, press "OK".

      3. Select "Install" button.

      4. Insert the MXIC adapter driver diskette, specify the driver 
	 path A:\NDIS2OS2 and press <Enter>.

      5. When complete above step to load MXNICF.OS2 into OS/2 system,
	 then configure your system.

      6. The same step as step 3, select "Configure" button.

      7. The screen will display "Configure" dialog box and select "LAN
	 adapters and protocols" then press "configure" button.

      8. The screen will display "LAPS Configuration" dialog box, move
	 highlight to "MXIC PCI Fast Ethernet Adapters NDIS2 MAC Driver" 
	 item in "Network Adapter" window, and select "NetBios" protocol. 
	 Press "OK".

      9. Installation is complete now. Reset your PC by turning it off
	  and on.

