                 Macronix International Co., Ltd.
                NetWare DOS ODI Driver Installation
              =======================================

        Copyright (C) 1996 by Macronix International Co., Ltd.
        All rights reserved.


NetWare DOS ODI Workstation Driver Installation (NetWare v3.xx & v4.xx)
-----------------------------------------------------------------------
This section describes the procedure to install
the NetWare v3.11 workstation driver for your adapter.

Requirements:
-------------
Macronix Driver Diskette

Installation Procedure:
-----------------------
Before you start with the installation process, make sure that
the adapter is properly installed and configured. Make sure
that your NetWare operating system is properly installed.

1. Run the following command in the order given below and
   press <Enter>:

   LSL
   MX32ODI
   IPXODI
   NETX (or VLM)

2. You can now log into your network.

Installation notes:
-------------------

1. Remember to specify LASTDRIVE=Z in the CONFIG.SYS file.

5. Edit the NET.CFG if you want to change some parameters.

   For example, if you're using a NetWare 3.11 workstation and
   wants to log into a NetWare v4.X  server. The default
   frame type of NetWare 3.11 is Ethernet 802.3, while that of
   NetWare v4.X  is Ethernet 802.2. Before you can log into
   the NetWare v4.X , make sure there is a protocol binding
   for Ethernet 802.3 in the server's NET.CFG file.

   This is normally included in the [MLID] section. A sample
   NET.CFG file is given below:

        Link SUPPORT
        buffers 8 1514
        mempool 4096

        link driver MX32MLID
        frame Ethernet_802.2
        frame Ethernet_802.3
        frame Ethernet_II
        frame Ethernet_snap

Note:
   There is another customer specific function,10FD(10HD),100FD(100HD),
   and AUTO.
   If you want the driver to run in full-duplex mode, you may specify
   10FD or 100FD in the NET.CFG file. The default mode is AUTO.
   The driver won't display any information about FD or HD(half-duplex).
   However, you may run the diagnostic program to see the speed mode.
   
---
All trademarks and brand names mentioned belong to their
respective owners.


-- THE END --
